FAQ
How can I install the 3D Peel and Stick Wall Tiles? Is easy to install?
Yes, it's quite easy to peel and stick, suitable for any place you want to change.
Step 1: Clean the surface
Clean the surface with a powerful grease-remover such as TSP (Tri-Sodium Phosphate). It is important to have a smooth surface in order to achieve a perfect grip. Make sure you allow enough time to the surface to dry properly.
*Tips: If your walls are freshly painted, wait up to three weeks before applying tiles.
Step 2: Plan & Cut
Use a pencil and ruler to lightly mark on the wall where each tile will be applied. Use a box cutter and a metal ruler with a cork backing to cut the tiles accurately.
Step 3: Peel & Stick
Fold down protective backing, (avoid touching adhesive - dust, dirt and oils will affect its strength) and press lightly to align first tile to your guide. Remove backing, press firmly once you are certain of placement with a plastic smoother to ensure best possible adhesion, especially the grout lines or the most concave area of the tile surface.
*Tips: Typically the backing adhesive will complete the bond to the wall within 48 hours. After 24 hours of installation, Press the grout lines firmly again with a plastic smoother to ensure more perfect adhesion.
Step 4: Finish & Enjoy
Repeat these steps to continue tiling your wall for a seamless look!
What are the ideal surfaces for installing 3D Peel and Stick Wall Tiles on?
Our adhesive tiles can be placed on all clean and sleek surfaces, also consistent lightly textured walls.
- Recommended Surface smooth ceramic tiles backsplash, smooth glass tiles backsplash, acrylic wall panel, pained gypsum, wall linoleum, stainless metal, mirror, laminate, wallpaper (if some corners are peeling, just peel them off and install tiles over them).
- Non-Recommended Surface oily wall, brick wall, stucco wall, stone wall, unfinished wall (gypsum or plaster), unpainted plywood.
*Please note that if the wall is not suitable or for other reasons, it is recommended to use 3M Purpose 45 spray glue to ensure the best adhesion.
Are the 3D Peel and Stick Wall Tiles Water-Resistant? And can I Put These in a Shower?
Yes, they are waterproof and can be used in the bathroom, but not recommended for use in the shower.For shower room usage, we only recommend our thicker backsplash stick tile. To provide the best environment for the tiles, ensure the bathroom has proper air circulation.
*Pls note that you must use tile trimming and caulk (or glass glue) for caulking to ensure that water does not enter the adhesive.
*Do not apply if walls are damp, moist or wet (walls must be perfectly dry during installation)
*Do not expose the wall tiles to direct steam or submerge in water.
Are 3D Peel and Stick Wall Tiles heat-resistant? Can I install them behind a stove/a fireplace?
Yes, they are heat resistant. They can be installed on any surface whose temperature does not exceed 49 °C (120 °F).
*Avoid any direct contact with a heat source or direct exposure to an open flame, it needs to be at least 12 inches away from the stove.
Can these be used on the floor, outdoors, or ceiling?
The 3D Peel and Stick Wall Tiles are not recommended for use on the floor, outdoors, or ceiling.
Can you install 3D Peel and Stick Wall Tiles over existing tile?
Yes, you may install 3D Peel and Stick Wall Tiles directly over an existing tiles such as ceramic or glass, as long as the tiles have been properly cleaned with a degreaser. Please ensure that the existing surface is sleek and you allow enough time to the surface to dry properly in order for the tiles to adhere properly.